Mount the Launch Monitor

Check the room, then mount the launch monitor on the ceiling above the hitting area.

View larger

1. 1

   Check the Room

   The ceiling should be 2,700–3,100 mm above the floor and level, and the tee at least 3,000 mm from the screen. Keep the launch monitor away from dust, heaters, air conditioners and vibration.

2. 2

   Mark the Mounting Point

   Measure the ceiling height (H) and find the center of the hitting area. Draw a line on the floor perpendicular to the screen, mark a point L mm toward the screen (table below), and transfer that mark to the ceiling.

   Offset L for your ceiling height H

   Ceiling height H (mm)	Offset L (mm)
   2,700	820
   2,750	836
   2,800	851
   2,850	867
   2,900	883
   2,950	899
   3,000	914
   3,050	930
   3,100	946

3. 3

   Fix the Ceiling Bracket

   Drive a screw through the center of the bracket into the ceiling mark, with the bracket's arrow facing the screen, then secure it with the seven screws. Keep it parallel with the screen and leave the screws slightly loose for now.

4. 4

   Hang the Launch Monitor

   Loosen the four screws already on the launch monitor, hang it on the bracket with its arrow pointing at the screen, press it flat against the bracket and tighten the four screws.

5. 5

   Connect Power and Ethernet

   Plug in the power adaptor, run the Ethernet cable straight to the PC and turn on the power switch. The red power light comes on and the green network light blinks.

Every measurement depends on the mount: the launch monitor must be level and its arrow must point straight at the screen. Check the level both ways with the Laser Indicator, and run Setup before fully tightening the bracket screws.